![]() This is needed as the GRUB bootloader currently can't handle all advanced zfs features, not specifying this flag on pool creation (or running 'zpool upgrade' on the pool at a later point in time) will make the pool incompatible with GRUB. Disables enabling all availabe zfs features. This is ideal for our example using a single disk and legacy (BIOS) boot.Ĭreate a ZFS Storage Pool using a single whole zpool create -d -o -o -o -o -o -o -o -f -o ashift=12 -o cachefile=/tmp/zpool.cache -O normalization=formD -O atime=off -O xattr=sa -O compression=lz4 -m none -R /mnt/funtoo rpool /dev/disk/by-id/foo We are letting ZFS automatically partition the drive. ZFS: Loaded module v0.6.5.6-0ubuntu10, ZFS pool version 5000, ZFS filesystem version 5 Drive Partitions Verify that the ZFS kernel module has dmesg | grep ZFS In the terminal, issue the following commands to install and load the required ZFS sudo apt-add-repository apt apt install -yes debootstrap gdisk zfs-initramfs Search for and open the Terminal application. Pressing Alt+F1 should also open this search bar. Once the desktop has loaded, open the search bar by left-clicking on the top-left icon ("Search your computer"). You will be presented with a "Welcome" dialog (titled Install (as superuser)). Using legacy (BIOS) boot mode, boot the ISO and allow Ubuntu to load the graphical environment. Once this has completed, remove and use this USB to boot the target system that will receive Funtoo Linux. Root # dd if=/path/to/iso/ of=/dev/sdg bs=4K In this example, indicates that the device is /dev/sdg.Ī quick and easy way to create a bootable USB is to write the ISO data to the USB device using dd. sd 15:0:0:0: Attached SCSI removable disk ![]() sd 15:0:0:0: Write cache: disabled, read cache: enabled, doesn't support DPO or FUA sd 15:0:0:0: Attached scsi generic sg6 type 0 scsi 15:0:0:0: Direct-Access Corsair Voyager Mini 3.0 PMAP PQ: 0 ANSI: 6 usb-storage 6-2:1.0: USB Mass Storage device detected usb 6-2: New USB device strings: Mfr=1, Product=2, SerialNumber=3 usb 6-2: New USB device found, idVendor=1b1c, idProduct=1a0c usb 6-2: new SuperSpeed USB device number 4 using xhci_hcd Then, inspect the kernel ring buffer with dmesg to identify the device name of your USB storage. Insert your blank USB media into a USB port. The size of the iso is approximately 1.5 GB.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |